What Does it Mean to Blowout Your Irrigation? Your sprinkler system is a worthwhile investment that needs adequate care and maintenance. As the freezing winter season approaches, it’s critical to put your sprinklers to bed. Doing so prevents water freezing inside the irrigation pipes and system components which could cause cracks or damage. Blowing out your system is one of the best methods to ensure your irrigation system is completely dry.
What Does it Mean to Blowout Your Irrigation?
The blowout method entails blowing in air at high pressure into the pipes to force all the water out of the irrigation system. The pressurized air pushes any water left in the lines and discharges it through the sprinkler heads. There’s no chance of any water remaining in the piping, making it the preferred method for winterizing your irrigation system.
With the other methods like the automatic and manual drain methods, there’s no way to ensure that there are no trace amounts of water left inside the pipes. Leaving even the smallest amount of water poses the risk of cracking or rupturing the irrigation system when the water freezes and expands. Apart from not eliminating all the water, other draining methods may not always be reliable because underground pipes can move with time.
Before you proceed, you will need to turn off the main water supply. This ensures that no additional water flows into the piping. Once you turn off the water, you’ll also need to open the hose bib on the main water supply that’s connected to the irrigation system to let the remaining water drain out.
If your watering system uses a timer, you will need to shut it down. This reduces the risk of electrical or mechanical faults while the irrigation system is offline. Depending on the type of timer you use, you can also set it to rain mode. That way, your programming will remain unchanged, and you can simply set it back to how it was after the winter.
Ensure that you blow out the zone farthest from the mainline first. This will ensure that you can adequately complete a zone-by-zone blowout. If your system is on uneven terrain, start your sprinkler blow out with the higher level zones first. The higher zones may need higher pressure, so you need to get them out of the way before lowering the pressure on the compressor.
Close the backflow valves on the irrigation system, then turn on your compressor, keeping your eye on the pressure. Remember to insulate all the above-ground fixtures of your irrigation system to prevent them from freezing.
Get a Quote Today!
More Great Tips for Homeowners:
- 5 Fall Landscaping Tasks
- Should We Install Lawn Irrigation?
- 5 Easy Landscaping Tips for Rental Properties
- Should I Mow the Lawn in the Winter?
- When to Plant Bulbs
- Tips for Weeding Garden Beds
- Dangers of Snow and Ice to Landscapes
- How to Minimize Your Ecological Housing Footprint